Brass trimmer question

[gunpoorboy1]

I just got a RCBS Trim Pro-2 case trimmer. In setting it up I'm having this problem.

The "Fine" and "Course" adjustment knobs each have a set screw to tighten and loosen for adjusting the depth of the cut. I'm going on the instructions and on the on-line videos which show that they each turn and operate separately. I can loosen the set screw on the "Course" adjustment bushing and it will rotate as it should on the cutter shaft but when I loosen the set screw on the "Fine" adjustment bushing, it will not rotate on the shaft. It's as if it's locked into place. It will not turn even when I take the set screw completely out.

Am I doing this wrong?

 

[blasternaz]

Are you at the end of it's adjustment? If you back off the set screw on the course adjustment wheel, does the fine adjustment work?

 

[gunpoorboy1]

No, as I stated in my original message, it will not move even with the set screw completely out.

 

[gunpoorboy1]

Just an update to say I sent the trimmer back for a refund. Moved on to a Hornady trimmer which is easier and more sturdy than the RCBS.