. 30 cal barrel face squaring tool

[Gunslinger55]

Need one to cut an AK barrel face square to bore for suppressor alignment. Anyone got one to borrow real quick? Probably do it in a driveway or Starbucks parking lot. I’ll buy the coffee …..lol

Brownells out of stock AK guy with shop never responded to email

 

[kendog4570]

I use a piloted aircraft 1" counter bore, run very slow speed, moderate/heavy feed with lots of dark cutting oil. Never had good results from the "gunsmith" tools from the usual suspects. Is the bore hard chromed? That changes things.
I dont loan tools, but I can do the service for you.

 

[kendog4570]

Nobody home??

 

[Creeker]

Dig up a 4 month old thread and then get bent when the OP doesn’t reply in a week and a half. :lol:

 

[kendog4570]

Not bent. Just wondering. Another way of saying "bump". Trying to help the guy out. The gunsmithing forum is a bit vacant. Hard pressed to find a thread that isn't old.

 

[kendog4570]

Yawn.....
Yawning while bent.

 

[kendog4570]

Snore.........