10 MM load info

[knockonit]

Looking for options. want to load some for the future shooting soon after rain arrives



looking for a reasonable load info for a 10mm round pushing a 180 gr copper clad flatnose,

powder i have is"

Winchester 231

CFE

Vihtavuori N350

not looking to beat and power or speed records, just need a round to plink and run semi autos reliably assume 5'' barrels, ect,

thanks
Rj

 

[Boriqua]

I started using Longshot couple years back at "intel6's" recommendation. I used in in the 10 and continue to use it for the 40.

For the 10mm and a 180 gr bullet I only used 8.3 gr of Longshot. Gives a nice pop so you know you are shooting something but doesn't beat up the gun. For range use I found it a great round and as accurate as I could shoot.

Probably only traveling a 100 fps faster than a good Quality 40 and seat of pants feel it was on par with factory 10mm range ammo.

 

[Suck My Glock]

5.5 grains of HP38 (same as Win231) using plated 180 grain plugs usually produced right around 1000 fps in my previous Glock 20s I have owned. It duplicate .40S&W ballistics, so might be a little weak to cycle 10mm handguns tuned for maximum loads with high power recoil springs, but in the Glock, they were just fine.

 

[nvgdude]

Normally use 10 grains of Blue Dot for just about any 180 grain load.

For 10mm I would normally want something slower than anything you have on hand. Blue Dot, AA#9 etc.

 

[jls in az]

Powder DIA. OAL MIN VEL Pressure MAX VEL PRESS
CFE Pistol 0.400" 1.260" 6.7 1,082 25,600 PSI 7.6 1,208 34,000 PSI

Win 231 0.400" 1.260" 5.2 944 29,700 PSI 5.8 1,061 34,900 PSI

Hope this helps.

 

[jls in az]

http://www.hodgdonreloading.com/data/pistol

 

[knockonit]

thanks folks, i can look up in reloading books info, was wanting hands on, experience on loads, to see the variance and difference.
again thanks, for info, it will go for a use as i ring up some rounds for the upcoming range run

Rj

 

[Boriqua]

Try the 8.3 gr of Longshot I mentioned. It's actually just a touch under starting load but ... It's still a nice little pop!

I wouldn't us the 231 for that round. I tried the hp38 in .357 and even loaded high side ... It was boring!