Recent content by muta4warrior

Got the chamber cut, chamfered, and polished. Cut the feed ramp on an old f'ed up extension (someone took a dremel to the feed ramps) and torqued to the barrel.

The Rio Salado Shooting Range spring swap meet is being held 5 April 2025 in the activities building to the left of the main range. Open to the public at 0700 till around 1500, parking and entrance are free. I'll have 12 feet of table with all sorts of reloading components, dies, equipment and...

Started this today.. was looking at all the barrel drops next to the lathe, found a bunch of old Olympic AR15 45 ACP barrel drops when I was cutting down 16" barrels to 5" for suppressors. So far, I only have the barrel threaded for an extension, now just have to verify bolt gap and torque the...

Customer brought this in.. Customer states that the ammo came from a sealed plastic bag his buddy gave him. :shifty: I didn't get a picture of the extractor that was bent into an "L". Even the top of the carrier was split from the front of the carrier to the cam slot..

I'll just leave this here... The after shot, had to replace all the internals and rear sight... :shhh:

This came in a few months ago.. bulged the lower out at the mag well pretty good also. It WAS a registered SBR.

Finished this up Monday, Midwest Industries 10.5" MPX handguard with a Dead Air Wolfman tucked under the handguard.

MANY, MANY, MANY pounds of tannerite and thousands of rounds of ammo were converted to fun out there. Early picture of my buddies trailer that we built for it there..

CMMG did this... 🤣

I have one for my 45-70, works very well.

Another that came across my bench... When you get a new Dremel kit for Christmas and go for that "crisp" trigger pull on your Lever gun, then wonder why the hammer won't stay back when you work the action... :roll: I found a replacement hammer and sear for it and they are currently on the...

pneuby all done..

Picked up a Steoger STR 9mm cheap, figured I would give Cerakote camo a try. I was already shooting Sig Dark Grey H-210 for a customer and always wanted to try the Crocodile Green, so ended up with this..

I wasn't happy with the all black look so I stripped it all down and did the slide and frame in Gun Metal Grey. Kinda has that matte stainless look now.