After a long 9 month and 9 day wait I got my Ghost-M out of jail and I was able to take it out to the range to test it out. It worked great with my Scorpion using a 3-Lug mount that I used Rockset to install on, I'm very happy with that so far! Unfortunately I had some cycling issues with my Glock 19. The Glock is all stock except for raised sights and a threaded barrel from Combat Armory. I experienced both failure to eject and failure to feed issues with two different mags shooting 147 grain CCI Blazer and 115 gain Fiocchi. I only tried with the suppressor in the long configuration. The Glock was able to cycle fine with the suppressor removed.
Anyone have any recommendations on what I should try?
I emailed Dead Air and they told me to lube the piston with high temp grease... Looked on Amazon and didn't see any so I haven't purchased any yet.
Glock issue with Ghost-M (cross posted from Title II and NFA Firearms and Items)
-
RomeoWhiskey
- New to ArizonaShooting.org
- Posts: 18
- Joined: March 29th, 2020, 10:18 pm
- Reputation: 0
- Location: East Valley
-
muta4warrior
- ArizonaShooting.org Member
- Posts: 289
- Joined: May 19th, 2018, 9:25 am
- Reputation: 12
- Location: East Mesa
Re: Glock issue with Ghost-M (cross posted from Title II and NFA Firearms and Items)
Are you running this https://deadairsilencers.com/product/booster-assembly/ on your can when you run the Glock or the 3 lug? Glocks need the booster to operate normally.
-
TheJediknight
- ArizonaShooting.org Member
- Posts: 187
- Joined: May 18th, 2018, 1:04 pm
- Reputation: 6
- Location: Phoenix
- Contact:
Re: Glock issue with Ghost-M (cross posted from Title II and NFA Firearms and Items)
muta4warrior wrote: ↑May 30th, 2020, 8:47 am Are you running this https://deadairsilencers.com/product/booster-assembly/ on your can when you run the Glock or the 3 lug? Glocks need the booster to operate normally.
This is true......
https://www.gemtech.com/l-i-d-linear-in ... upler.html
