10/22 Barrel fitting

[Pro2a]

[Again, I would first confirm that the barrel channel in the receiver is smooth and not roughed up, and then I would slowly sand down the barrel until it slides in with a snug fit. That's if you want to take it off on your own in the future.

Ok, I'll be feeling on that hole.
I believe between grease and maybe sandpaper, that b**** is going in tight.

[Basher]

Along these lines, I need a PWS carbon barrel removed from a TacSol 10/22 receiver. Any shops on the east side who can do that for me without much of a wait?

[Pro2a]

AZ556, there does seem to be a fair amount of grooves on one side of the hole, but I think it's best to just work on the barrel as suggested. Getting some grease today.