Ad blocker detected: Our website is made possible by displaying online advertisements to our visitors. Please consider supporting us by disabling your ad blocker on our website.
AZ_Five56 wrote: ↑August 2nd, 2020, 7:15 pm
[Again, I would first confirm that the barrel channel in the receiver is smooth and not roughed up, and then I would slowly sand down the barrel until it slides in with a snug fit. That's if you want to take it off on your own in the future.
Ok, I'll be feeling on that hole.
I believe between grease and maybe sandpaper, that b**** is going in tight.
Along these lines, I need a PWS carbon barrel removed from a TacSol 10/22 receiver. Any shops on the east side who can do that for me without much of a wait?
AZ556, there does seem to be a fair amount of grooves on one side of the hole, but I think it's best to just work on the barrel as suggested. Getting some grease today.