80% ar lower finished up
- Man_d0wn
- ArizonaShooting.org Member
- Posts: 132
- Joined: June 14th, 2019, 1:14 am
- Reputation: 5
- Location: Phoenix
80% ar lower finished up
my father Inlaw has had this jig for years and i came across a cheap raw lower. Is there anything i should check out or need to know before putting rounds down range? This was my first build and came out pretty good i think lol.
- Squirrel_Slayer
- New to ArizonaShooting.org
- Posts: 20
- Joined: October 15th, 2020, 7:44 pm
- Reputation: 0
- Location: Florence
Re: 80% ar lower finished up
Thats a whole lot of chips! lol Good job!
I have a few of those EP80 polymer 80% lowers coming that i'm excited to try.
I have a few of those EP80 polymer 80% lowers coming that i'm excited to try.
- Rattles336
- New to ArizonaShooting.org
- Posts: 22
- Joined: September 12th, 2018, 8:48 am
- Reputation: 0
- Location: Phoenix
Re: 80% ar lower finished up
Someday I will have to give this a try. I say of everything fits and locks up well just send it.
- XJThrottle
- ArizonaShooting.org Bronze Supporter
- Posts: 2883
- Joined: June 26th, 2018, 5:43 pm
- Reputation: 7
- Location: Phoemex
Re: 80% ar lower finished up
Dry fire it a couple time to make sure the FCG is good. Then load one in a mag and fire. Then two in a mag, and repeat.
I only suggest this as one of my buddies did an AR10 80% and something wasn't right with the FCG and it wanted to run away on him...
I only suggest this as one of my buddies did an AR10 80% and something wasn't right with the FCG and it wanted to run away on him...