Need some straightforward machining done for reasonable $

Discuss work on firearms; whether that is making yours from the ground up, milling an 80%, putting together a kit, or fine tuning a trigger job.
Post Reply
User avatar
Intel6
ArizonaShooting.org Member
ArizonaShooting.org Member
Posts: 130
Joined: July 24th, 2018, 3:43 pm
Reputation: 1
Location: SE AZ

Need some straightforward machining done for reasonable $

#1

Post by Intel6 »

I need about 0.125” taken off the back of two Areo precision handguards. It is just a simple end mill cut with no real precision other than being square. I don’t mind paying a fair price but one smith I checked had a $70 setup fee for each piece plus the regular labor charge? I decided to see if anyone here might know of anyone in AZ that could do this more reasonably.

Thanks for any help you can provide.


User avatar
Kinked_Chrome
ArizonaShooting.org Member
ArizonaShooting.org Member
Posts: 98
Joined: December 11th, 2018, 6:01 pm
Reputation: 8
Location: Mesa

Re: Need some straightforward machining done for reasonable $

#2

Post by Kinked_Chrome »

If you still need this work done, send me a PM. I have a little machine shop in Mesa that I run on the side.
Post Reply