Any machinists on AZS or you like?

Discuss work on firearms; whether that is making yours from the ground up, milling an 80%, putting together a kit, or fine tuning a trigger job.
Post Reply
User avatar
hairygreek
ArizonaShooting.org Member
ArizonaShooting.org Member
Posts: 217
Joined: May 26th, 2018, 8:40 pm
Reputation: 5
Location: Tucson

Any machinists on AZS or you like?

#1

Post by hairygreek »

I got a an Argentinian Sarco dust cover base to put a scope on FAL and then found a Chinesium Stanag picatinny rail adaptor for it. It would work but to put my optic on there I would need a cantilever/one piece mount which are all 1.5 inches high and basically way too tall when it's all done. If the mount was 4 pic sections longer I could use optimum height scope rings. And the Chinesium mount isn't that good of quality.

So if I had a machinist make a Stanag mount from longer pic rail (or modify my sarco base) I could solve this issue. Anyone here a machinist or know one?


Post Reply