Page 1 of 1
Anyone in town with a 12/20 ton press??
Posted: August 5th, 2022, 12:40 am
by Az_Gunner
Just got approved for an SBR stamp, did a cut & crown, but I need to press off a front sight gas block on my AK, and wondering if anyone near the 85233 (Gilbert) area can lend a hand before I go buy one - problem is I don’t have the room for one at the moment so I was hoping someone would allow me to use theirs - TIA
Re: Anyone in town with a 12/20 ton press??
Posted: August 5th, 2022, 5:35 am
by Doc
Take it to Lee Armory. I’m sure they can get you taken care of for less than the cost of buying and storing a press.
Re: Anyone in town with a 12/20 ton press??
Posted: August 7th, 2022, 12:52 pm
by Az_Gunner
Doc wrote: ↑August 5th, 2022, 5:35 am
Take it to Lee Armory. I’m sure they can get you taken care of for less than the cost of buying and storing a press.
Thanks for the heads up - I was contacted by a member here that had one, and we were able to get it taken care of - tested it out yesterday, and everything ran
