I got a an Argentinian Sarco dust cover base to put a scope on FAL and then found a Chinesium Stanag picatinny rail adaptor for it. It would work but to put my optic on there I would need a cantilever/one piece mount which are all 1.5 inches high and basically way too tall when it's all done. If the mount was 4 pic sections longer I could use optimum height scope rings. And the Chinesium mount isn't that good of quality.
So if I had a machinist make a Stanag mount from longer pic rail (or modify my sarco base) I could solve this issue. Anyone here a machinist or know one?
Any machinists on AZS or you like?
-
hairygreek
- ArizonaShooting.org Member
- Posts: 222
- Joined: May 26th, 2018, 8:40 pm
- Reputation: 5
- Location: Tucson
