Anyone in town with a 12/20 ton press??

Discuss work on firearms; whether that is making yours from the ground up, milling an 80%, putting together a kit, or fine tuning a trigger job.
Post Reply
Az_Gunner
ArizonaShooting.org Member
ArizonaShooting.org Member
Posts: 56
Joined: April 13th, 2022, 12:09 pm
Reputation: 0
Location: Gilbert

Anyone in town with a 12/20 ton press??

#1

Post by Az_Gunner »

Just got approved for an SBR stamp, did a cut & crown, but I need to press off a front sight gas block on my AK, and wondering if anyone near the 85233 (Gilbert) area can lend a hand before I go buy one - problem is I don’t have the room for one at the moment so I was hoping someone would allow me to use theirs - TIA


User avatar
Doc
ArizonaShooting.org Member
ArizonaShooting.org Member
Posts: 1601
Joined: December 17th, 2018, 5:04 pm
Reputation: 21
Location: Middle of nowhere but hotter

Re: Anyone in town with a 12/20 ton press??

#2

Post by Doc »

Take it to Lee Armory. I’m sure they can get you taken care of for less than the cost of buying and storing a press.
Az_Gunner
ArizonaShooting.org Member
ArizonaShooting.org Member
Posts: 56
Joined: April 13th, 2022, 12:09 pm
Reputation: 0
Location: Gilbert

Re: Anyone in town with a 12/20 ton press??

#3

Post by Az_Gunner »

Doc wrote: August 5th, 2022, 5:35 am Take it to Lee Armory. I’m sure they can get you taken care of for less than the cost of buying and storing a press.
Thanks for the heads up - I was contacted by a member here that had one, and we were able to get it taken care of - tested it out yesterday, and everything ran 👌🏼
Post Reply