Page 1 of 1

press roller handles

Posted: April 13th, 2019, 3:07 pm
by knockonit
Well i have a few presses, two have the dillon roller handle, and the last one has the 8ball, factory, so i'm in the market for a new possibility

was wondering if someone has been using the inline fabrication (ergo model)on a dillon, i generally stand while reloading, so bending over is not gonna be something i wanna do, i have bench sorta set to a height, that i kinda rock left to right off one leg, kinda odd I know but it works for me, allows me to check powder drop each time and my hips don't hurt from standing static

Share what ya got, if ya don't have one, don't share, and frankly if you don't use it on a dillon, i'm not really interested info on any other presss
thanks

happy sat
Rj

Re: press roller handles

Posted: April 15th, 2019, 9:22 am
by NBC_LT
I've been using an inline fabrication roller handle for my RCBS JR2 and Magma Engineering Casemaster Jr. for years now - good products - wish I would have bought them sooner.

Re: press roller handles

Posted: April 15th, 2019, 11:47 am
by knockonit
NBC_LT wrote: April 15th, 2019, 9:22 am I've been using an inline fabrication roller handle for my RCBS JR2 and Magma Engineering Casemaster Jr. for years now - good products - wish I would have bought them sooner.
so is it the ergo handle or the regular roller handle.
thanks
rj

Re: press roller handles

Posted: April 16th, 2019, 10:54 am
by NBC_LT
I'm using the ergo type.

Re: press roller handles

Posted: April 28th, 2019, 6:13 pm
by knockonit
well i had a chance to visit and try a different press handle, and while it was roller bearing unit, i really couldn't tell dif between tmy dillon handle that much, some diff , but not enough to jump on board, also the odd angle of the dangle of the handle was odd.

so i went with the blue

thanks to all
Rj

Re: press roller handles

Posted: June 30th, 2019, 7:23 am
by Loenuff
Love my Dillon roller