Brass trimmer problem.

Discuss ammunition and reloading topics here.
Post Reply
User avatar
gunpoorboy1
ArizonaShooting.org Member
ArizonaShooting.org Member
Posts: 298
Joined: June 16th, 2018, 7:03 pm
Reputation: 1
Location: Phoenix

Brass trimmer problem.

#1

Post by gunpoorboy1 »

I just got a RCBS Trim Pro-2 case trimmer. In setting it up I'm having this problem.

The "Fine" and "Course" adjustment knobs each have a set screw to tighten and loosen for adjusting the depth of the cut. I'm going on the instructions and on line videos which show that they each turn and operate separately. I can loosen the set screw on the "Course" adjustment Bushing" and it will rotate as it should on the cutter shaft but when I loosen the set screw on the "Fine" adjustment bushing, it will not rotate on the shaft. It's as if it's locked into place. It will not turn even when I take the set screw completely out.

Am I doing this wrong?


User avatar
pcmacd
New to ArizonaShooting.org
New to ArizonaShooting.org
Posts: 13
Joined: December 27th, 2021, 4:50 pm
Reputation: 0
Location: Maricopa County

Re: Brass trimmer problem.

#2

Post by pcmacd »

Call RCBS. They will figure it out.
Post Reply